Recalculation of Post Heights in Roof

Hello,

I like to input many of my posts using the roof module. I put the plates in first, then add the posts where required. When you input the posts, you can choose the height that you would like them to end at (ex: for posts that you would like to support a roof, and end at the second floor height).

My problem comes when I make changes to the roof and recalculate the Roof Design (5-9). All the posts that I have set at a height other than Zero recalculate to end at Zero.

I have tried using the TE Plate setting on post input but this always just seems to go to Zero...

Does anyone know how to keep the post height settings after the Roof Design is recalculated?

Thanks,

Dan

Joachim,

Thanks for the reply. I have started a new project and I am also trying to recreate the error. I can't do it either. It seems like it happens late in the project, maybe after I recalculate the roof and the program is asking me if I want to separate plates (if intersecting roof surfaces have been inputted?). I will pay more attention to when it happens and post a position when the time comes.

Thanks,

dan

I have attached a position.

I have just lowered the roof by 2 feet, and I am recalculating Roof Design. When I do this, one post is recalculated to zero, and another plate and posts disappear.

What is happening here?

Thanks,

Daniel