Ok - can you figure this one out:
I was about to make a extra wall (roof truss) in TF storey. Then I wanted to copy roof truss from one of the other walls, with wall macro and insert in new wall.
Then I saw that in almost all the other walls, the roof truss items was in the right place, but the wall volume, was far away under the building. When i check the heights of the walls, they are all the same - both the walls where roof truss design is inside the wall volume and the walls, where wall volume is far away.... The bottom edge UA should be 313237 mm - and it is for all walls. But when I in wall design, where wall volume is far away, measure, from bottom of wall, I can see that bottom of wall is -313237. How this can be, I don't knoe.