Perpendicular Drillings

Kayaker · 25. März 2008

I deleted all processes and did a unite shapes. Now I am having trouble doing perpendicular drillings? :roll:

Der_Planer · 25. März 2008

Drillings at the upper face could be impossible, because there is no material.
The other faces should accept drillings.

What about the coordinate system? Where is your local x-axis?
I guess, you try drillings into the end faces?

Kayaker · 26. März 2008

Der_Planer,

I am attaching another JPEG. image. You can see the assisting geometry points in location showing the faces I want to drill. The JPEG drilling wrong shows the drilling received when trying to drill the larger upper plate I receive a message wrong process.

Thanks!

Kayaker

Der_Planer · 26. März 2008

I think, you did not not understand me.
You have switched on the global coordinate system, but that's not interesting.
Every part has it's own system, you can see it with 2-07-1
and you can change it with 2-07-2 (only parts with no processes).

You can also switch on the axis of all parts (1-7-1 Dicam - axis) to see the part's length direction.

Once more: I guess, the direction of the axis in your column cap is wrong.
When you unite 2 parts with different coordinate directions, the result will have the direction of the 2nd selected part.

Perpendicular drillings can not be made in end faces, only in side faces.

Jason · 28. März 2008

Hi Kayaker,

As previously discussed if you still would like a material list of all the steel plates you cannot unite all the pieces.

Also if you do unite the pieces you cannot use perpendicular drilling 3-04-5. You will need to use point to point 3-04-6.

Perpendicular Drillings

Jetzt mitmachen!

Teilen