Roof Suface Properties

I don't know how asphalt shingles really look, but I guess this will do it.

- unzip and extract the bmp file into the folder: \Dietr...\Gif\Freitext\...
- rename it to "textur_1...9.bmp" (overwrite one of the existing)

Go back to roof calculation, make a new (or change an existing) roof definition, using the new texture.

Hi Kayaker,

there is only little chance to help without the position file (zgb).
I guess, roof calculation does not meet exactly in one point.

Please open the roof calculation table and control the values. All ground angles, line lengths and roof pitches should be identically with 6 digit precision.
I would correct the values, increase the pitch of line 1 and 21 about 0,2° and recalculate. If the surfaces are correct now, I would decrease the 1+21 pitch again, but not exactly to the point.

If it doesn't help at all, I would delete the automatic roof calculation and build it new with manual roof faces, defining every face with 3 clicks: roof input with 2-03.

Zitat von Kayaker

...When I apply roof surface properties to line 20 see attachment Problem Line 20 this is what I end up with....

It seems, that you changed roof properties for each single surface!?
Before you try the steps from my last post, you should change roof properties for all surfaces at once.
Roof design 3-01, then collect all roof faces.

Zitat von Kayaker

Now I need to change the roof surface to shingles.

After you have copied the asph-shingle.bmp into the correct folder, rename it to "textur_1.bmp", go to roof design and use 3-01 for all all surfaces at once.

You cannot use other file names, because exactly these names are embedded into the internal "texture sets". And you cannot define a new texture set by yourself.
If you want to keep the old files, make a backup of them. These files are made for own use, in the way I described. They were made as placeholder (dummy). The texture set for "Textur_0...9" shows the picture as a 1x1-m pattern on all faces of the part.