Help with tennon process

Diese Seiten wurden speziell für die Benutzer unserer Software installiert, um sich untereinander und mit uns, Informationen, Neuigkeiten, Bilder und Dateien auszutauschen. Egal ob Dietrich's Abbundprogramm oder DC-Statik, hier sind alle Holzbau Profis richtig. Natürlich auch die ohne Holzbausoftware ;)


Wenn Sie selbst aktiv werden wollen, melden Sie sich unverbindlich mit einem Benutzernamen und einem Passwort an. Klicken Sie hierzu auf der linken Seite den Punkt "Benutzerkonto erstellen" an.


Wir wünschen unseren Besuchern einen informativen und angenehmen Aufenthalt bei Dietrich's FIX


Ihr Team Dietrich's Online - Holzbau ist unser Programm

    I have a signature curve I do with most of my work. Its like a Japanese style girt on a gable end.


    I create this by drawing it then use the extrude function in dcam to turn it into a 3d piece of wood. When I draw in the king posts, and then add a tenon to it, it does not account for the curve in the wood. Sometimes it even says "Connection not possible"


    Any idea what is going on here? Any way to get the drawing to look tight?


    My clients are always asking what is going on with that when I show them the 3d renderings.

    Hello kablamnetworks,


    the processes in D-CAM only take into account the "rough" beam without any other processes. That is why you get the gap in the tenon connection. You can help yourself by creating an "assisting beam" parallel to the collar with a small height so that top surface of the assisting beam just touches the surface of the curve. You then create the tenon between the post an the assisting beam, explode the tenon connection in "single beam". Now you can delete the assisting beam and notch out the mortise in the curved beam.


    Best regards,


    Jens

    Jens Krause

    Then to get the mortise through the curved beam you could try using the mortise function assigned from the smart tag library. I think that will do the mortise for you.

    Jim Rogers
    Sneads Ferry, NC, USA


    Version 24.01.4, 23.01.4, 22.02.2, 20.02 13.04, 12.03, 11.06, 10.02, 9.05, 8.04, 7.03, and 5.05

    For joinery to work on an extruded beam you must extrude the beam correctly. Normally the X axis must be the beam length.


    Once extruded you can also use the "Housing" input found under the "Reduction" tab in the tenon command. This will account for the curve in the beam. You need to measure the amount of housing needed as seen in the video below.


    Tenon On Curved Beam Video

    Jason Kilmartin
    Dietrich's N.A

    Very nice, and easy....

    Jim Rogers
    Sneads Ferry, NC, USA


    Version 24.01.4, 23.01.4, 22.02.2, 20.02 13.04, 12.03, 11.06, 10.02, 9.05, 8.04, 7.03, and 5.05

Jetzt mitmachen!

Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!

Benutzerkonto erstellen Anmelden