Hiprafter - I don't get it...

Diese Seiten wurden speziell für die Benutzer unserer Software installiert, um sich untereinander und mit uns, Informationen, Neuigkeiten, Bilder und Dateien auszutauschen. Egal ob Dietrich's Abbundprogramm oder DC-Statik, hier sind alle Holzbau Profis richtig. Natürlich auch die ohne Holzbausoftware ;)


Wenn Sie selbst aktiv werden wollen, melden Sie sich unverbindlich mit einem Benutzernamen und einem Passwort an. Klicken Sie hierzu auf der linken Seite den Punkt "Benutzerkonto erstellen" an.


Wir wünschen unseren Besuchern einen informativen und angenehmen Aufenthalt bei Dietrich's FIX


Ihr Team Dietrich's Online - Holzbau ist unser Programm

1. offizieller Beitrag

    Hi. I have this roof - almost pyramid roof. In my world this roof is made of 4 roof elements. When making the one element, I need a hip rafter (as far as I can see). But when I insert it, it always is inserted so the one hip rafter is shared by two roof surfaces. This I don't want. In each of the 4 hip lines, there should be two hip rafters - one at each side of the hip line.


    How to do that?

    Sincerely Yours. M. Sc. E. Thorvald, Denmark
    (Dietrichs version 7.03).

    I was thinking about slanting rafters - but then I thought "no", they would not do it. But ok - I have to give it a try.

    Sincerely Yours. M. Sc. E. Thorvald, Denmark
    (Dietrichs version 7.03).

    Ok - it worked fine! Thank's for the tip. The roof beams are not perfect - i.e. meeting each other perfectly symmetric, but there is a reason for that: The groundplan is square, but the two pairs of roof sides have slightly different angles to make this straight line in the top. But since the rafters are not going to be visible anywhere, these small differences will be covered.

    Sincerely Yours. M. Sc. E. Thorvald, Denmark
    (Dietrichs version 7.03).

    Hi, Thorvald,
    sometimes in same situation I am using separating cut (general or vertical) in Dcam. Example: 2 x bigger beam you can divide to 2 smaller beams.

    Vilmantas Liutkus
    Constructor engineer
    Roof constructions, timber frame - shield houses

    • Offizieller Beitrag

    This is not a good idea if you need the data of each single beam on a machine. Even without machine the solution of Jens is the better one.

    Viele Grüße,
    Joachim Neumann (Dietrich's Technology GmbH)
    Software für den Holzbau, Abbund, Holzrahmenbau, Blockbau, Ingenieurholzbau und für die Fertighausindustrie

    Ok - new problem with this - or at least similar roof. The profile that should cover the ridges of the roof. First I tried to input it as a slanting rafter, but the profile was cut, so that was not a big success. Then I input it as a rafter and rotated it, to go over this edge of the roof. But the rafter, doesn't have the correct slope. So how to do that??


    The top "normal" ridge of the roof can probably be done with a ridge beam.

    Sincerely Yours. M. Sc. E. Thorvald, Denmark
    (Dietrichs version 7.03).

Jetzt mitmachen!

Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!

Benutzerkonto erstellen Anmelden