When saving the current view in D-CAM, I've long had the beam cross-section applied to the timber. In 9.04 and above, I've been able to round this to a fraction of "0", such that it would round to the nearest inch. That is, if I had an 7.5" x 7.5" timber, it would print out 8x8 on the drawing. I cannot seem to do this in 10.02, although it worked just fine in 9.04. The option for "0" no longer appears in the units. See the attached screen captures.
Any ideas? This throws a giant wrench in how I used D-CAM for generating shop drawings for a few clients, so, any help is greatly appreciated...